ProcommPlus سوالات و پاسخ‌ها

To capture the output on Procomm Plus for Windows, you can typically use the built-in capture function. Here’s how you can do it:

1. Open Procomm Plus and connect to the desired session.
2. Once connected to the session where you want to capture output, go to the “Capture” menu.
3. Select “Start Capture” from the menu options.
4. Choose a location and filename for the capture file when prompted.
5. Click “Save” to start capturing the output. The session’s output will now be saved to the specified file.
6. To stop capturing, go back to the “Capture” menu and select “Stop Capture.”

Remember that the exact instructions might vary slightly depending on the version of Procomm Plus you are using.

No, the software won't work for what you need. Access their official website to see the supported products that the software can be used with. According to the official description, the software supports the following:

Terminal Emulations
AT&T 605 & 4410
ADM31, 3a & 5
ADDS 60 & 90
ANSI BBS
DEC VT 52, 100, 102, 220 & 320
Data General D100, D200 & D210
Heath 19
Esprit 3
IBM 3101, 3161 (block mode), 3270 (asynchronous) & IBM PC
RIPscrip 1.54 (not available in Procomm Connections)
TeleVideo 910, 912, 920, 922, 925, 950 & 955
TTY
VIDTEX
Wyse 50, 60, 75 & 100
File Transfer Protocols
ASCII
CompuServe B+
IND$FILE
Kermit
RAW ASCII
Zmodem
Xmodem
Ymodem
Ymodem-G
1K-Xmodem
1K-Xmodem-G

No, ProcommPlus is not optimized to work with Windows 7. According to the information on the official website, this application is developed to run with Windows XP. In Windows 7, right click the setup package and select Properties > Compatibility. From the drop down list select Windows 7 and then run it as Administrator. This is the only way that you can try to run the software in Windows 7.